SwingRiser 19

Single post, industrial, 1,600 lb, Open/Close: 19 seconds

SWINGRISER 19 is an extremely-reliable and elegant, continuous duty, industrial grade, hydraulic swing gate operator. Its graceful, smooth lift and swing raises gate leaf a full 12 inches during the gate open cycle to clear obstacles like snow, rocks, curbs and road inclines. Optional locking pin mechanically locks when gate gently lowers at end of its cycle. Frequently chosen for high profile or high security locations, HySecurity’s unique SwingRiser solves specialized site challenges with finesse.

SwingRiser 19 single-post opens or closes a gate leaf, up to 1,600 lb and 16 ft width, in 19 seconds. The HydraSupply, electrical controls and manual override are remotely located in a separate enclosure, up to 100 ft from the gate. SwingRiser outer post is zinc flame sprayed for superior corrosion resistance. Standard SwingRiser posts are 80 inches (203 cm) tall, assembled as left hand or right hand and inward swing or outward swing, as well as 90° or 100° swing. Custom height SwingRiser posts can be ordered to fit your gate size. Ordering the correct SwingRiser configuration is critical as the speed and all elements described above cannot be field reconfigured. HySecurity provides a SwingRiser Order Form that must accompany every order to insure accuracy and customer satisfaction.

Easily configure gate operation to specific site requirements with unequalled Smart Touch Controller. PC software simplifies configuration and troubleshooting using Smart Touch Analyze and Retrieve Tool (S.T.A.R.T.). Upload latest software, troubleshoot system and save operator configurations. Programmable dual or sequenced gate integration. Three configurable user relays plus optional Hy8Relay™ - an accessory module providing eight additional programmable relay outputs.

Connect and Report: Optional web based HyNet™ Gateway connects the perimeter gates/barriers with your security monitoring station. Securely report gate system tailgating, gate hits, failure to operate, and more, in real time to maintain perimeter security. Additionally, configure email alerts to communicate issues to installer, facility or security responders.

Note: The top of the SwingRiser post must be mounted to a structural column or wall that will support the entire weight of the swing gate panel throughout its arc. Excessive speed, insufficient column support or insufficient footings may cause gate sag, premature post and actuator wear and other serious operator malfunction. HydraSupply enclosure may be located up to 100 ft (30.5 m) from post. For longer than 100 ft runs, call HySecurity for hose specifications. Up to 100 ft (30.5 m) runs require 1/4 inch hose/fittings. For runs longer than 50 ft (15 m) AND installed in cold climates, which routinely get below 0° F (18° C), use 3/8 inch braided hose. Operator price includes up to 50 ft (15 m) of 1/4 inch hydraulic hose (custom cut to size by HySecurity according to installer''s field measurements). Hoses are pre-filled with hydraulic fluid and supplied with quick disconnects. Submit completed and signed operator and hose order forms with each order.

To enable fully automatic operation, this gate operator requires a MINIMUM of one external entrapment protection sensor to monitor potential entrapment zones in either the open or close direction of travel. Visit www.hysecurity.com/gatesafety for more information on UL 325 standards and gate safety.

HySecurity offers a 24VDC motor version of the SwingRiser with a DC Power Supply for 115V or 208-230V single-phase. Optional AC Power Supply w/HyInverter AC™ provides UPS battery backup for 208/230VAC single-phase AC gate operators, providing up to 100 cycles UPS backup after an AC power loss.**